• 企業動態
• 礦廠五一設備檢修忙 手拉葫蘆來
• 低溫環境下使用手拉葫蘆需要注意
• 手拉葫蘆參與刷洗酸洗管道更換工
• 手拉葫蘆多少角度算斜拉歪吊
• 廢品回收站使用手拉葫蘆吊裝家具
• 什么是高效型手拉葫蘆？它的優點有
• 手拉葫蘆參與澧縣文廟檢修工作
• 手拉葫蘆質量怎么樣?倒鏈省力耐
• 影響手拉葫蘆零部件軸承滾珠性能
• 怎么讓飛鴿手扳葫蘆更省力

Manually Hoist

Maintenance Manual

維護方法

Maintenance methods

1.

使用完畢應將葫蘆清理干凈并涂上防銹油脂，存放在干燥

地方，防止手動葫蘆受潮生銹和腐蝕。

Hoist clean up after use and should be coated with anti-rust oil,stored in a

dry place,moisture to prevent rust and corrosion chain hoists.

手動葫蘆

2.

維護和檢修應由較熟悉葫蘆機構者進行，用煤油清洗葫蘆

機件，在齒輪和軸承部分，加黃油潤滑，防止不懂本機性能原理

者隨意拆裝。

Maintenance and repair should be more familiar with hoist bodies were

carried out Mechanical cleaning hoist with kerosene, Gears and bearings in

part,Add Huangyou Run slip,Prevent those who do not understand the

principle of free disassembly machine performance.

3.

葫蘆經過清洗維修，應進行空載試驗，確認工作正常，制

動可靠時，才能交付使用。

After cleaning maintenance hoist,Load test should be carried out,Confirm

working properly,Braking and reliable, theBe delivered.

4.

制動器的摩擦表面必須保持干凈。制動器部分應經常檢

查，防止制動失靈，發生重物自墜現象。

Brake friction surfaces must be kept clean.Brake parts should be

inspected regularly,Prevent brake failure,Place heavy objects from falling

phenomenon.

5.

手動葫蘆的起重鏈輪左右軸承的滾柱，可用黃油粘附在已

壓裝于起重鏈輪軸頸的軸承內圈上，再裝入墻板的軸承外圈內。

Around the sprocket Manually hoist lifting the ball bearing,Butter has been

pressed in adhesion can be installed on the lifting sprocket bearing inner ring

on the journal,Load bearing wall and then outside the circle.

6.

手動葫蘆在安裝制動裝置部分時，注意棘輪齒槽與棘爪爪

部嚙合良好，彈簧對棘爪的控制應靈活可靠，裝上手鏈輪后，順

時針旋轉手鏈輪，就將棘輪、摩擦片壓緊在制動器座上，逆時針

旋轉手鏈輪，棘輪與摩擦片間應留有空隙。

Manual hoist brake part of the installation,Note with the pawl ratchet claw

alveolar Department of meshing well Spring on the pawl control should be

flexible, reliable,Sprocket to get started after installation,Clockwise bracelet

round,Will ratchet, pressed the brake friction plate seat,Counterclockwise

rotation bracelet round,Ratchet and friction plate should be left between the

gap.

7.

為了維護和拆卸方便，手鏈條其中一節系開口鏈（不允許

焊死）。

In order

to maintain and facilitate

the demolition,

hand chain in whic

h a

series open-chain (no welded).

8.

在加油和使用手動葫蘆過程中，制動裝置的摩擦面必須保

持干凈，并經常檢查制動性有，防止制動失靈引起重物自墜。

In

the

refueling

process

and

the

use

of

manual

hoist,Brake

friction

surfaces must be kept clean,And

regular inspection of braking there,Prevent

brake failure caused by heavy objects from falling.

使用規則

Use Rules

1.

嚴禁超載使用。

Overloading is strictly prohibited to use.

2.

嚴禁用人力以外的其他動力操作。

Prohibited use of human power other than the operating

3.

在使用前須確認機件完好無損，傳動部分及起重鏈條潤滑

良好，空轉情況正常。

Before Use, be sure that parts intact,Transmission parts and lifting the

chain oiled,Idling situation to normal.

4.

起吊前檢查上下吊鉤是否掛牢。嚴禁重物吊在尖端等錯誤

操作。起重鏈條應垂直懸掛，不得有錯扭的鏈環，雙行鏈的下吊

鉤架不得翻轉。

Checked before lifting the upper and lower hook is hanging in prison.

Weight suspended from the tip is strictly prohibited errors such operations.

Lifting chain should be hung vertically, without twisting the wrong link, double

chain hook frame shall turn next.

5.

操作者應站在與手鏈輪同一平面內拽動手鏈條，使手鏈輪

沿順時針方向旋轉，即可使重物上升；反向拽動手鏈條，重物即

可緩緩下降。

The operator should stand on the same plane with the bracelet round

hands pulled the chain, so that bracelet round clockwise, you can increase the

weight; reverse hands pulled the chain, you can slow down weight.

6.

在起吊重物時，嚴禁人員在重物下做任何工作或行走，以

免發生人身事故。

In lifting weights, strictly prohibited in any work under hea

vy objects or

walking in order to avoid injury.

7.

在起吊過程中，無論重物上升或下降，拽動手鏈條時，用

力應均勻和緩，不要用力過猛，以免手鏈條跳動或卡環。

In the lifting process, regardless of weight up or down, hands pulled the

chain, the force should be uniform gentle, not too much force, so as not to beat

or hand chain ring.

8.

操作者如發現手拉力大于正常拉力時，應立即停止使用。

防止手鏈條磨損。

Operator found hand pulling tension greater than normal, they should

immediately stop using. Hand chain to prevent wear and tear.

以上由杭州武林機器有限公司收集整理。